Aquaforest Probiotic Reef Salt 25kg Box

Fully synthetic marine salt created for cultured corals. Its formula is designed to create the best conditions for marine animals. The micronutrients and macronutrients contained in the formula fulfil the demand of corals for proper growth and pigmentation. Probiotic bacteria contained in the salt reduce the content of nitrates and phosphates and prevent the growth of pathogenic bacteria in the marine aquarium. After dissolving the salt, freshly prepared marine water can be used immediately. When setting up new aquariums, it is recommended that the first animals are placed no sooner than 10-14 days after filling the aquarium. Due to the content of probiotic bacteria the dKH value should be maintained at 6.5-8.0. Higher values may have a negative effect on the growth of SPS corals.

Supplied in a 25kg box.

Directions For Preparation:

Dissolve the salt in previously prepared demineralized water. Water temperature should be about 24°C (75°F). For salinity of 33 ppt (1.025 S.G.), dissolve about 390 g (13.75 oz.) in 10 l (2.7 US gal) of water. Stir the solution vigorously for about 15 minutes. Once the salt is fully dissolved and the solution is clear, the saline water is ready to use. Keep the salt in a dry and dark place. Once dissolved, use the salt within 5 days. Evaporation can change water parameters, so keep freshly mixed saltwater in a sealed container if you don’t use it right away. You should check the salinity of your saltwater again before use if you store it for a couple of days. This product is for aquarium use only. Not suitable for human consumption. Keep away from children. Safety data sheet available on request.

Detailed Information:

Aquaforest products are manufactured in the EU under strict laboratory supervision to meet the highest quality standards. Each product is prepared from carefully selected raw components in quantities proven to yield consistent composition.

How is our Marine Salt product range tested?
We mix our Marine Salt in 1 metric tonne (2204lb) batches, and 3 separate samples per batch are collected during the production stage for testing. Each of these samples is dissolved in 15 litres (4US gal) of RO water. Our experienced team of professionals perform ICP-OES analysis to verify that the chemical composition is within consistent range, and to rule out the presence of unwanted contaminants at the same ti me. Note: Even though our salt is thoroughly mixed, not every bucket/box will be identical. The parameters can vary slightly between containers and around a 2-3% variation is acceptable. This fluctuation is a result of both physical properties of the mix and the limitations of the processing techniques available. These variations are still smaller than the typical margin for error for popular hobbyist test kits.